Installation & Information

Installation & Information

whatlock® will operate through glass, wood, ceramic tiles, laminates and non-ferrous metals. Suitable for doors, drawers & cabinets up to a maximum of 25mm (1 inch) thick.

The simplest & quickest way to install your whatlock® child safety lock is to use the 3M adhesive pads. Please allow 24 hours to set. For added strength, install with the screws supplied. Check that you have all the parts in the components list. Ensure all surfaces are clean, dry and free from dust. To use the screws, you will need as above and a bradawl & a small Phillips screwdriver. Always keep the key in a safe place & out of reach of children. Our whatlock® child proof cupboard locks can be used in the kitchen, bathroom, office – anywhere in the house. 

Step 1

On the template. Peel off the narrow adhesive strip (1). Affix onto the front face of the cupboard side with the guideline over the inside edge.

 

Step 2

Fold the template onto the inside wall of the cupboard (2). Mark the two strike plate hole locations.

 

Step 3

Leave the template in position. Peel the backing paper from the foam tape. Close the door firmly onto the template.

 

Step 4

Open the door. The template will have transferred to the exact location for the lock on the inside of the door. Mark the four holes. Remove the template.

 

Step 5

To use the 3M adhesive pad. Remove the backing strip from the pad. Place firmly into position by matching the holes to the pre-marked locations. To use the screws, as above and use a bradawl to start the screw hole and use 2 of the screws provided.

 

Step 6

To use the 3M adhesive pad, remove the backing strip from the pad. Place firmly into position by matching up the holes to the pre-marked locations. To use the screws, as above and use a bradawl to start the screw hole and use 4 of the screws provided.

 

Simple to Use

To open, pass the magnetic cupboard lock over the front of the door in line with the location of the lock. The catch will release, allowing the door or drawer to open. Automatically locks the magnetic drawer lock when the door or drawer is closed. Invisible from the outside.

 

Locking bar

The lock can be switched off and left in the open position when not in use. To activate, hold the blue beak (a) in and then push the blue bar (b) from one side to the other.

 

 To order your new whatlock® simply, visit our store page here, or to purchase extra locking keys visit here.